KNIVES AND BLADES

High-Low
View as Grid List
  1. Swann-Morton No.3 Scalpel Handle Swann-Morton No.3 stainless steel handles, with a measure or graduation on the reverse side. Supplied individually wrapped and boxed in units of 10, non sterile. Fitment for Blades – No.10a, 11. The industry standard craft scalpel with disposal blade. Blades not included. Quickview
  2. Metamark Guard Knife Blades Replacement blades supplied in packs of 5. Quickview
  3. OLFA DC-5 – Advanced Handy Blade Disposal Case The OLFA® DC-5 with belt clip is designed to make life easier, faster and safer for anyone who uses a Snap-Off cutter. To use the snap case, pull down the front flap, insert your snap-off cutter into the slot (with the blunt segment extended) and pull towards you to snap it off and let it fall safely inside. Once the case is full you can pull open the top flap and discard used blades safely, making the case ready to use again Quickview
  4. OLFA SAC-1 – Ultra Slim Graphics Cutter The OLFA® SAC-1 is an ultra slim, snap-off cutter with a unique 30° angled blade. The idea behind the acute angle is to get the sharpest point of the blade onto the surface to be cut, when cutting from a typical height on a table. The cutter features an auto-lock mechanism that keeps the blade firmly in place when cutting. It also features a built-in pocket clip and blade snapper. The body is made from stainless steel and will remain rust-free forever. Quickview
  5. OLFA XA-1 – Design Cutter with Auto-Lock The OLFA® XA-1 benefits from X-DESIGN™ excellence. This means that it has a very comfortable, anti-slip grip, allowing you to use maximum pressure to cut, safely. The elastomeric grip takes a lot of the pressure off your hand, resulting in greatly reduced strain over long periods of use. The XA-1 has an auto-lock to keep the blade in place during use, and a built-in pocket clip and blade snapper. Pre-loaded with an Excel Black™ ultra sharp blade. Quickview
Loading ...
Load More ...
High-Low
View as Grid List